Samsung SCH-R910 (Indulge)

Supported Carriers:

Cricket, Cricket STX, Cricket Corporate, Revol, Mobi, Page Plus, Ntelos, Blue Wireless, Alltel, ClearTalk

Phone Pre-Setup:

Houdini Provisioning Instructions
- First make sure the Samsung R-910 is in the on position. Make sure your connection between the handset and computer are secure and snap in correctly using the MTC Cable. Wait for the charging symbol to appear on the screen. Continue normally with the Houdini Detect button and complete the Houdini process.

Pre-Provisioning
- Phone must be in USB Debugging(Diag) mode, Instructinos below:
- Menu > Settings > Applications > Development > Check USB Debugging
- If above instructions do now work perform the following listed below:
- Dial **87284 and set UART and USB to Modem
- Phone is now in proper mode to load drivers and continue with the provisioning process

Additional Issues
- Always make sure the drivers for the handset have been installed correctly.
- If your handset is not being detected view the most common issues below
- Damaged data port on the handset itself. Check for water damage or damage to the data port on the handset.
- USB driver conflict (Most Common) Download and install the drivers we supply on our website. Houdini is fully compatible with Windows 2000,XP,Vista.
- Handset has not been added to the Houdini database.
- Net 2.0 framework is needed to run Houdini. Download from the support tab on our site.

Device and Programming Instructions:

Bring up Dial-pad

Dial ##626* followed by SPC Code 000000 or 468346 and select Edit

Press Enter at MEID, ESN, and Akey screen

Enter MDN (10 digit phone number) and press Enter

Press Enter at MCC screen

Enter MIN/MSID (10-digit phone number) and press Enter

Press Enter at IMSI MCC screen

Press Enter at IMSI NMSID screen

Press Enter at SID/NID screen

Verify HomeSID and press Enter

Press Enter at NID screen

Continue to press enter on all upcoming SID/NID screens until number 20

Press Enter at Pchn Sys A, Schn Sys A, Pchn Sys A, and Schn Sys B screens

Press Enter at CDMA Home Reg, CDMA fSid Reg and CDMA fNID Reg screens

Press Enter at ACCOLC screen

Press Enter at HomePage VoiceSO, HomeOrig VoiceSO, Roam Orig VoiceSO screens

Press Enter at Slot Cycle Index screen

Press Done

Phone will power cycle and programming is now complete.

Cable: MTC

Symbol: Bear

Cable Image:

Find Programming