Samsung Galaxy SM N900P Note 3 Sprint

Phone Pre-Setup Kit Kat

Previously activated 4G LTE SIM must be inserted before attempting to flash this device.

 

  • Install Drivers for Samsung Galaxy Note 3
    Open Dial Pad and Dial Kitkat 4.4 (##366633# ) or
    Dial *#7284# or ##3424#
    Leave UART untouched
    Select Qualcomm USB Settings
    Select DM + MODEM + ADB
    Press OK then Back until you are at the Home Screen
    Phone is ready to be provisioned
    (Remember after flashing to return and put phone back to MTP+ADB)
    If the devices does not detect you may have to perform a master reset. (Instructions Below)
    Menu > Settings > Back up and Reset > Factory Data Reset

 

If Houdini says the device cannot be provisioned but the device is showing in your device manager, please follow the these instructions.

4.1.2

  1. With the device plugged:
  2. Dial *#7284# or ##3424# 
  3. Set UART to PDA
  4. Select Qualcomm USB Settings
  5. Set to MTP + ADB
  6. Disable USB Debugging Mode (Menu> Settings> Developer Options)
    1. If you don't see Developer Options, Enable them by going to Menu> Settings> About Device and Tap "Build Number" 7 times. This will enable Developer Options.
  7. Allow Drivers to load completely.  This can take up to 5 minutes.
  8. Device should now appear in device manager as Samsung Mobile USB CDC Composite Device
  9. Now..With the phone still plugged in, turn off and turn on (Restart the device)
  10. After the phone finished restarting, Dial *#7284# or ##3424# 
  11. Make sure PDA is still selected and select Qualcomm USB Settings
  12. Select DM+Modem+ADB
  13. Again allow the drivers to load.
  14. Detect

4.3/4.4

  1. With the device plugged in:
  2. Dial ##366633#
  3. Disable DM Mode
  4. Disable USB Debugging Mode (Menu> Settings> Developer Options)
    1. If you don't see Developer Options, Enable them by going to Menu> Settings> About Device and Tap "Build Number" 7 times. This will enable Developer Options.
  5. Allow Drivers to load completely.  This can take up to 5 minutes.
  6. Device should now appear in device manager as Samsung Mobile USB CDC Composite Device
  7. Now..With the phone still plugged in, turn off and turn on (Restart the device)
  8. After the phone finished restarting, Dial ##366633# 
  9. Enable DM Mode
  10. Again allow the drivers to load.
  11. Detect

 

Post-Provisioning
  • Set Network Mode to "CDMA" (Instructions below)
    Select Menu then Settings
    Under Wireless and Networks, choose More Settings
    Scroll down to Mobile Networks
    Select Network Mode and set to CDMA
Programming
  • Dial ##000000# (If SPC is not "000000" then you must obtain correct SPC from your provider"
    Select Edit
    Select MDN
    Enter new MDN (10 digit phone number) and press OK
    Select MSID
    Enter new MIN (10 digit number) and press OK
    Press Back then Done
    Phone will power cycle and programming is now complete
Reference Links
USB Cable
  • MTC Bear
Tips and Tricks
  • Alternative Activation
    • If the device is not functioning properly after a flash has completed, attempt to active with the Decimal form of the MEID (ex. 256XXXXXXXXXXXXXXX) instead of the HEX "IMEI" (ex. 990000XXXXXXXX)
Video Tutorials
  • Coming soon
Loading Activity...